Rafter clamp SPZ
Product details
- Clamping force up to 12,000 N
- For all roofing and timber frame constructions
- SPZ 80 K with 17 mm hexagonal bolt and heat‐resistant pressure plate with sintered steel insert, which can be tilted up to 35°
= Show Spareparts
| Order number | Opening | Throat depth | Rail | Weight |
| mm | mm | mm | kg | |
|---|---|---|---|---|
|
SPZ60K
|
600 | 120 | 27x13 | 2.9 |
|
SPZ80K
|
800 | 140 | 30x15 | 5 |
Hammer-in tip
First of all, the tip is driven into the rafter. The clamp is then quickly closed, to allow you to start right away with powerful clamping.
Broad impact surface
The broad impact surface makes it easier to drive in the clamp.
Special tilting pressure plate
With the SPZ 80 K, the special tilting pressure plate ensures problem-free clamping even when working with sloping parts. It can be tilted by up to 35°.
Sturdy hexagonal bolt
The SPZ 80 K's tough hexagonal bolt allows powerful yet controlled tightening, with the help of a torque wrench.
- Carpentry and woodwork
- Shell construction
- For clamping rafters and beams
- Use the product only in its original condition.
- Use the product only for its intended purpose. Improper use can cause personal injury or property damage.
- Wear safety glasses to protect your eyes.
- Wear work or assembly gloves to protect your hands.
- Wear safety footwear to protect your feet.
- Thew handle must always be free of oil and grease to prevent slipping.
- Keep the product out of reach of children.
- Small parts must not be swallowed or inserted into body openings.
- Check the product for damage before each use and make sure that all moving parts are working properly.
- A damaged product must not be used.
- Follow the care instructions for each product – see www.bessey.de.
- Use only original BESSEY spare parts
- The clamping tool must not be used for lifting, pulling or leaning.
- The clamping tool must not be used to secure cargo during transportation.
- The clamping tool may only be tightened by hand without any additional aids.
- The clamping tool must not be used for permanent installation.
- Regularly check that the end stop is working properly when using clamps.
- Fixed and sliding bracket made of tempered steel, galvanised
- Spindle with trapezoidal thread in tempered, rolled steel, phosphated
- Toggle made of steel, galvanised
- Pressure plate made of steel, phosphated
- Regular maintenance is necessary – only then can a secure hold be guaranteed (no slipping of the sliding bracket).
- Clean the rails with solvent.
- Always keep the rail free of grease, oil or dried glue, waxes and silicone-based release agents.
- Clean and oil the spindle regularly.
- Clean and oil the pressure plate regularly.
- If the rail is shiny, roughen both narrow sides with emery cloth (100 grain).