Earth (ground) clamp LP / TP with thumb screw

Product details
  • With malleable cast iron arms
  • Practical thumb screw
  • Grounding connection hole in the upper part
  • TP‐...F‐RK: Cable strain relief at rail end / ring internal diameter 30 mm
steel
spareparts = Show Spareparts
Order number Opening Throat depth Rail Hole Ø Strength of current Weight
mm mm mm mm A kg
LP-1F
150 60 20x5 105 300 0.53
TP-1F
150 80 25x6 105 400 0.76
TP-2F
150 60 30x8 11 600 1.12
TP-1F-RK
150 80 25x6 105 400 0.78
TP-2F-RK
150 60 30x8 11 600 1.12
  • Metal construction
  • Locksmith work
  • Car body construction
  • Earthing using ground clamps
  • Use the product only in its original condition.
  • Use the product only for its intended purpose. Improper use can cause personal injury or property damage.
  • Wear safety glasses to protect your eyes.
  • Wear work or assembly gloves to protect your hands.
  • Wear safety footwear to protect your feet.
  • Thew handle must always be free of oil and grease to prevent slipping.
  • Keep the product out of reach of children.
  • Small parts must not be swallowed or inserted into body openings.
  • Check the product for damage before each use and make sure that all moving parts are working properly.
  • A damaged product must not be used.
  • Follow the care instructions for each product – see www.bessey.de.
  • Use only original BESSEY spare parts
  • The clamping tool must not be used for lifting, pulling or leaning.
  • The clamping tool must not be used to secure cargo during transportation.
  • The clamping tool may only be tightened by hand without any additional aids.
  • The clamping tool must not be used for permanent installation.
  • Regularly check that the end stop is working properly when using clamps.
  • Lower section made of zinc die-cast, galvanised
  • Hollow profile rail made of steel, cold-drawn, galvanised
  • Spindle with trapezoidal thread in rolled steel, burnished
  • Pressure plate made of steel, cold pressed, galvanised
  • Wing nut made of steel, powder-coated
  • Regular maintenance is necessary – only then can a secure hold be guaranteed (no slipping of the sliding bracket).
  • Clean the rails with solvent.
  • Always keep the rail free of grease, oil or dried glue, waxes and silicone-based release agents.
  • Clean the fluting on the rails with a steel brush.
  • Clean and oil the spindle regularly.
  • If the lower part slips, turn the grub screw a 1/4 turn further (TG, KRE, KREV only).
  • Clean and oil the pressure plate regularly.
Back to product overview