Die‑cast zinc screw clamp LM

Product details
  • Clamping force up to 1,500 N
  • Clamping arms manufactured in toughened die cast zinc black powder coated to prevent chemical corrosion
  • Comes with protective cap
  • Small and easy to handle
  • Light weight
wood plastic sensitive materials
spareparts = Show Spareparts
Order number Opening Throat depth Rail Weight
mm mm mm kg
LM10/5
100 50 15x5 0.24
LM15/5
150 50 15x5 0.27
LM20/5
200 50 15x5 0.3
LM25/5
250 50 15x5 0.32
LM30/5
300 50 15x5 0.35
LM15/8
150 80 20x5 0.51
LM20/8
200 80 20x5 0.55
LM25/8
250 80 20x5 0.6
LM30/8
300 80 20x5 0.64
LM20/10
200 100 25x6 0.9
LM25/10
250 100 25x6 0.95
LM30/10
300 100 25x6 1.01
LM40/10
400 100 25x6 1.1
LM50/10
500 100 25x6 1.24
LM60/10
600 100 25x6 1.3
LM80/10
800 100 25x6 1.58
  • Furniture and joinery works
  • Kitchen construction and shop fitting
  • Interior fittings
  • DIY
  • Rapid, gentle clamping
  • Use the product only in its original condition.
  • Use the product only for its intended purpose. Improper use can cause personal injury or property damage.
  • Wear safety glasses to protect your eyes.
  • Wear work or assembly gloves to protect your hands.
  • Wear safety footwear to protect your feet.
  • Thew handle must always be free of oil and grease to prevent slipping.
  • Keep the product out of reach of children.
  • Small parts must not be swallowed or inserted into body openings.
  • Check the product for damage before each use and make sure that all moving parts are working properly.
  • A damaged product must not be used.
  • Follow the care instructions for each product – see www.bessey.de.
  • Use only original BESSEY spare parts
  • The clamping tool must not be used for lifting, pulling or leaning.
  • The clamping tool must not be used to secure cargo during transportation.
  • The clamping tool may only be tightened by hand without any additional aids.
  • The clamping tool must not be used for permanent installation.
  • Regularly check that the end stop is working properly when using clamps.
  • Upper and lower section made of zinc die-cast, powder-coated
  • Solid profile rail made of steel, cold-drawn, galvanised
  • Spindle with trapezoidal thread in rolled steel, galvanised
  • Handle made of wood, water-based paint
  • Pressure plate made of steel, cold pressed, galvanised
  • Protective caps made of plastic
  • Regular maintenance is necessary – only then can a secure hold be guaranteed (no slipping of the sliding bracket).
  • Clean the rails with solvent.
  • Always keep the rail free of grease, oil or dried glue, waxes and silicone-based release agents.
  • Clean the fluting on the rails with a steel brush.
  • Clean and oil the spindle regularly.
  • Clean and oil the pressure plate regularly.
Back to product overview