Light duty bar clamp U‑style LMU

Step‐over clamping U‐shape

The rail is made of quality steel drawn in a single piece for durability and strenght. The U‐shape of the rail enables step‐over clamping up to 20 mm so you can get to those hard‐to‐reach places.

Sliding arm

The sliding arm is made of die-cast zinc. It is light, stable and break-resistant.

Protective caps

Particularly sensitive workpieces are effectively protected thanks to the protective caps. For all-round gentle clamping.

• Furniture and joinery works
• Kitchen construction and shop fitting
• Interior fittings
• DIY
• Rapid, gentle clamping

• Use the product only in its original condition.
• Use the product only for its intended purpose. Improper use can cause personal injury or property damage.
• Wear safety glasses to protect your eyes.
• Wear work or assembly gloves to protect your hands.
• Wear safety footwear to protect your feet.
• Thew handle must always be free of oil and grease to prevent slipping.
• Keep the product out of reach of children.
• Small parts must not be swallowed or inserted into body openings.
• Check the product for damage before each use and make sure that all moving parts are working properly.
• A damaged product must not be used.
• Follow the care instructions for each product – see www.bessey.de.
• Use only original BESSEY spare parts
• The clamping tool must not be used for lifting, pulling or leaning.
• The clamping tool must not be used to secure cargo during transportation.
• The clamping tool may only be tightened by hand without any additional aids.
• The clamping tool must not be used for permanent installation.
• Regularly check that the end stop is working properly when using clamps.

• Lower section made of zinc die-cast, galvanised
• Rail made of galvanised steel
• Spindle with trapezoidal thread in rolled steel, galvanised
• Handle made of wood, water-based paint
• Pressure plate made of steel, cold pressed, galvanised
• Protective caps made of plastic

• Regular maintenance is necessary – only then can a secure hold be guaranteed (no slipping of the sliding bracket).
• Clean the rails with solvent.
• Always keep the rail free of grease, oil or dried glue, waxes and silicone-based release agents.
• Clean the fluting on the rails with a steel brush.
• Clean and oil the spindle regularly.
• Clean and oil the pressure plate regularly.