Malleable cast iron screw clamp TPN with 2‑component plastic handle

Signature 2

Point 1

Point 2

Point 3

Point 4

Point 5

• Furniture and joinery works
• Carpentry and woodwork
• Kitchen construction and shop fitting
• Shell construction
• Interior fittings
• DIY
• Powerful and rigid clamping

• Use the product only in its original condition.
• Use the product only for its intended purpose. Improper use can cause personal injury or property damage.
• Wear safety glasses to protect your eyes.
• Wear work or assembly gloves to protect your hands.
• Wear safety footwear to protect your feet.
• Thew handle must always be free of oil and grease to prevent slipping.
• Keep the product out of reach of children.
• Small parts must not be swallowed or inserted into body openings.
• Check the product for damage before each use and make sure that all moving parts are working properly.
• A damaged product must not be used.
• Follow the care instructions for each product – see www.bessey.de.
• Use only original BESSEY spare parts
• The clamping tool must not be used for lifting, pulling or leaning.
• The clamping tool must not be used to secure cargo during transportation.
• The clamping tool may only be tightened by hand without any additional aids.
• The clamping tool must not be used for permanent installation.
• Regularly check that the end stop is working properly when using clamps.

• Upper and lower section made of reinforced malleable cast iron, powder-coated
• Hollow profile rail made of steel, cold-drawn, galvanised
• Spindle with trapezoidal thread in rolled steel, burnished
• Handle made of 2-component plastic
• Pressure plate made of steel, cold pressed, galvanised
• Protective caps made of plastic

• Regular maintenance is necessary – only then can a secure hold be guaranteed (no slipping of the sliding bracket).
• Clean the rails with solvent.
• Always keep the rail free of grease, oil or dried glue, waxes and silicone-based release agents.
• Clean the fluting on the rails with a steel brush.
• Clean and oil the spindle regularly.
• If the lower part slips, turn the grub screw a 1/4 turn further (TG, KRE, KREV only).
• Clean and oil the pressure plate regularly.