Earth (ground) clamp LP / TP with tried‑and true wooden handle
Product details
- With malleable cast iron arms
- Ergonomically shaped wood handle
- Grounding connection hole in the upper part
= Show Spareparts
| Order number | Opening | Throat depth | Rail | Hole Ø | Strength of current | Weight |
| mm | mm | mm | mm | A | kg | |
|---|---|---|---|---|---|---|
|
LP-1
|
150 | 60 | 20x5 | 105 | 300 | 0.5 |
|
TP-1
|
150 | 80 | 25x6 | 105 | 400 | 0.76 |
Signature 18
Point 1
Point 2
Point 3
Point 4
Point 5
- Metal construction
- Locksmith work
- Car body construction
- Earthing using ground clamps
- Use the product only in its original condition.
- Use the product only for its intended purpose. Improper use can cause personal injury or property damage.
- Wear safety glasses to protect your eyes.
- Wear work or assembly gloves to protect your hands.
- Wear safety footwear to protect your feet.
- Thew handle must always be free of oil and grease to prevent slipping.
- Keep the product out of reach of children.
- Small parts must not be swallowed or inserted into body openings.
- Check the product for damage before each use and make sure that all moving parts are working properly.
- A damaged product must not be used.
- Follow the care instructions for each product – see www.bessey.de.
- Use only original BESSEY spare parts
- The clamping tool must not be used for lifting, pulling or leaning.
- The clamping tool must not be used to secure cargo during transportation.
- The clamping tool may only be tightened by hand without any additional aids.
- The clamping tool must not be used for permanent installation.
- Regularly check that the end stop is working properly when using clamps.
- Lower section made of zinc die-cast, galvanised
- Hollow profile rail made of steel, cold-drawn, galvanised
- Spindle with trapezoidal thread in rolled steel, burnished
- Handle made of wood, water-based paint
- Pressure plate made of steel, cold pressed, galvanised
- Regular maintenance is necessary – only then can a secure hold be guaranteed (no slipping of the sliding bracket).
- Clean the rails with solvent.
- Always keep the rail free of grease, oil or dried glue, waxes and silicone-based release agents.
- Clean the fluting on the rails with a steel brush.
- Clean and oil the spindle regularly.
- If the lower part slips, turn the grub screw a 1/4 turn further (TG, KRE, KREV only).
- Clean and oil the pressure plate regularly.