One‑handed clamp EHZ with 2‑component handle

Parallel handle with pump lever

The ergonomically shaped handle with pump lever runs parallel to the rail. That way, balanced, safe handling is always guaranteed.

Rapid move button

This button allows you to move the sliding arm at any time, quickly and with minimum effort.

Plastic pressure caps

The removable plastic caps provide a non‐marring soft touch for use with wood and finished metal surfaces.

Versatility

Fixed arm and pressure plate are produced and tempered from a single piece of high quality BESSEY steel. Clamping is resilient and elastic.

Signature 43

Point 1

Point 2

Point 3

Point 4

Point 5

• Furniture and joinery works
• Kitchen construction and shop fitting
• Staircase construction
• Interior fittings
• Dry construction
• DIY
• One-handed clamping

• Use the product only in its original condition.
• Use the product only for its intended purpose. Improper use can cause personal injury or property damage.
• Wear safety glasses to protect your eyes.
• Wear work or assembly gloves to protect your hands.
• Wear safety footwear to protect your feet.
• Thew handle must always be free of oil and grease to prevent slipping.
• Keep the product out of reach of children.
• Small parts must not be swallowed or inserted into body openings.
• Check the product for damage before each use and make sure that all moving parts are working properly.
• A damaged product must not be used.
• Follow the care instructions for each product – see www.bessey.de.
• Use only original BESSEY spare parts
• The clamping tool must not be used for lifting, pulling or leaning.
• The clamping tool must not be used to secure cargo during transportation.
• The clamping tool may only be tightened by hand without any additional aids.
• The clamping tool must not be used for permanent installation.
• Regularly check that the end stop is working properly when using clamps.

• Fixed and sliding bracket made of tempered steel, galvanised
• Upper and lower section made of reinforced PA6 plastic
• Spindle with trapezoidal thread in rolled steel, burnished
• Handle made of 2-component plastic
• Pressure plate made of steel, cold pressed, galvanised
• Protective caps made of plastic

• Regular maintenance is necessary – only then can a secure hold be guaranteed (no slipping of the sliding bracket).
• Clean the rails with solvent.
• Always keep the rail free of grease, oil or dried glue, waxes and silicone-based release agents.
• Clean and oil the spindle regularly.
• Clean and oil the pressure plate regularly.
• If the rail is shiny, roughen both narrow sides with emery cloth (100 grain).